Tel:0510-82727145
0510-83721050
Sales:18851513152(Miss Wei)
13616142609(Mr. Zhang)
Fax:0510-82727146
E-mail:yanpn@foxmail.com
Add:No. 30-29 Huixi Road, Liangxi District, Wuxi City, Phase II Photoelectric New Materials Science Park
Static eliminator maintenance method
time:2019-01-27 09:49:15 click:
Speaking of static eliminators, I don’t know if everyone is familiar with them. Some people are definitely unfamiliar. In fact, static eliminators are mainly used in industrial production and belong to the electronic product series. So what are the classifications and what are the precautions? So today, Xiaobian will help you introduce relevant knowledge.
First, the power supply, gas source requirements 1 power supply must have a ground wire, and to ensure adequate grounding. The transformer must be well grounded and the ground wire knob should be checked for tightness before each use. 2 The gas source used must be effectively filtered. Sometimes a secondary filtration unit is needed. The filter should be cleaned in time. Otherwise: water, oil and dust/dust particles enter the ion generation chamber and adhere to the inner wall of the plastic part. When accumulated to a certain extent, the ion needle will ignite it. As a result, the plastic parts gradually form a honeycomb focal length, and the amount of ion removal is gradually reduced; in particular, a safety hazard is generated.
Second, in addition to the electrostatic effect adjustment 1 In addition to the static effect, the static electricity time is inversely proportional to the air pressure. The air pressure should be 0.3Mpa-0.7Mpa. 2 The distance between the gun head, the wind nozzle and the electrostatic field and the angle all affect the effect of static electricity, and should be adjusted until satisfactory.
Third, routine maintenance
1. The air gun/wind nozzle is easy to break. Pay attention to the anti-collision when using the air gun, and pay attention to the anti-fall after use. Even if the air nozzle is fixedly installed, take care to prevent object collision.
2. The air gun air pressure regulating valve is moderately and appropriately put into the universal anti-rust lubricating fluid.
3. When cleaning the ion gun air ion needle and ion needle chamber, it is necessary to use anhydrous alcohol to use water. When cleaning, first power off, then use the camera to unscrew the small plastic cover (also called air accelerator) in front of the ion air gun head, use a cotton swab dipped in anhydrous alcohol to clean the inner chamber of the ion needle and ion needle, and inside the inside. The stains and dirt are cleaned.
4, the ion air gun is best to add a foot switch, or through the electromagnetic valve and mechanical action linkage control, not only can improve the use of the effect, but also extend the service life.
All of the above knowledge is about the maintenance of static eliminators. I don't know what you have learned after reading them. In fact, this knowledge is very helpful for people who often use static eliminators, so everyone should take a good look.